Description
The 74LS73 is a dual in-line JK flip-flop IC. It contains two independent J-K flip-flops with individual J-K, clock, and direct clear inputs. The 74LS73 is a positive pulse-triggered flip-flop.
JK Flip Flop Pin Description:
Pin Number
Pin Name
Description
4
Vcc
Powers the IC typically with 5V
13
Ground
Connected to the ground of the system
JK Flip Flop – 1 / JK Flip Flop – 2
1,5
Clock-1/ Clock-2
These pins must be provided with a clock pulse for the flip-flop
2,6
Clear-1 / Clear-2
Resets the flip-flop by clearing its memory
3, 12
K-1/ K-2
Input pin of the Flip Flop
16,7
J-1 / J-2
Another Input pin of the Flip Flop
15, 10
Q-1(bar) / Q-2 (bar)
The inverted output pin of Flip Flop
14,11
Q-1 / Q-2
Output Pin of the Flip Flop
Features of 74LS73:
Dual JK Flip Flop Package IC
Operating Voltage: 5V
High-Level Input Voltage: 2 V
Low-Level Input Voltage: 0.8 V
Operating temperature range = -55 to 125°C
Available in a 14-pin PDIP package
Note:
Complete Technical Details can be found on the
74ls73 datasheet
given at the end of this page.
Where to use 74LS73
The 74LS73 is a dual in-line
JK flip-flop
IC. This means it has two JK flip-flops inside it and each can be used individually based on our application. J-K input is loaded into the master while the clock is high and transferred to the slave on the high to low transition. This IC can be used in latching applications or can act as a small programmable memory for your project.
How to use 74LS73
As told earlier 74LS73 has two negative edge triggered JK flip flops, and the IC is powered by +5V. The below circuit shows a typical sample connection for the
working of JK flip-flop
The J and K pins are the input pins for the Flip-Flop and the Q and Q bar pins are the output pins. Input pins are pulled down to the ground through a 1k resistor, this way we can avoid the pin in floating condition. That is the pin will held to the ground when the button is not pressed and when the button is pressed the pin will be held to supply voltage.
The reset button should be pulled up through a 1K resistor and when grounded will reset the
flip-flop
. The clock signal for the JK flip-flop is responsible for changing the state of the output. The flip-flop will change its output only during the rising edge of the clock signal. The clock signal here is just a push button but can be the type of pulse like a
PWM signal
. The output state of the flip-flops can be determined from the truth table below.
Normally during regular operation of the IC, the reset pin will be set high and the clock pulse of known frequency will be supplied to the clock pin, then the values of J and K will be varied based on the input signals and the respective output will be obtained on the Q and Q bar pins.
Applications of 74LS73:
Shift Registers
Memory/Control Registers
EEPROM circuits
Latching devices
Component Datasheet
7473 Dual JK Flip-Flop DATASHEET
Reviews
There are no reviews yet.