Description
The 10V 0.5W Zener diode is a standard component used for voltage regulation and transient overvoltage protection. By industry standards, this is most commonly represented by the 1N5240 or the BZX79-C10 series. You are requesting 2 pieces, which are widely available as generic components for breadboarding or PCB repair.
Technical Specifications
| Parameter | Specification |
| Nominal Zener Voltage ($V_Z$) | 10V |
| Power Dissipation ($P_D$) | 0.5W (500mW) |
| Package Type | DO-35 (Small Glass Axial) |
| Tolerance | $\pm 5\%$ |
| Operating Temperature | -65°C to +200°C |
Understanding the Zener Principle
This component is engineered to operate in the reverse breakdown region. When the input voltage exceeds 10V, the diode begins to conduct, effectively “clamping” the potential to a stable 10V by shunting excess current to ground.
To operate as a voltage regulator, you must use a series current-limiting resistor ($R_s$). This resistor limits the current ($I_Z$) flowing through the diode, preventing it from exceeding its 0.5W power rating. Without this resistor, the diode will quickly overheat and fail, typically in a short-circuit state.
Application & Replacement Notes
-
Thermal Safety: To keep this 500mW device safe, ensure the current does not exceed the limit. Using the formula $I_{Zmax} = P_D / V_Z$, your maximum current should be kept below ~50mA ($0.5W / 10V$).
-
Replacement: When sourcing a replacement, ensure it is a 10V 500mW Zener diode in the DO-35 package.
-
Troubleshooting: If the circuit output is 0V or significantly lower than 10V, test the Zener diode with a multimeter. A failed Zener diode will typically show a dead short (near 0 ohms) in both directions.
Reviews
There are no reviews yet.